Vastu Guidelines for Car Parking and Garage in Factory

In a factory or industrial setup, proper planning of car parking and garage areas is crucial for operational efficiency and energy balance. According to Vastu Shastra, the placement of parking lots and garages affects not only the flow of vehicles but also employee satisfaction, safety, and prosperity. Incorrect placement can lead to accidents, vehicle damage, financial losses, and delays in operations.

1. According to scripture, place for car- parking or garage, whether in a factory or bungalow, should always be I the north- west angle. It is also said- ‘vayvye pshumandirem’

2. In case there is o place left in the north- west corner, then garage can be built I the south- east corner also.

3. Never keep a car parking place in north- east corner.

4. Western and southern sides are ideal sites for parking.

5. If the number of vehicle is identical with that of the fate number of vehicle– owner, then possessor is lucky ad his vehicle also proves gainful.

6. It is best to have slope in car- parking towards the northern direction.

7. When a vehicle is being moved out, one should turn to the right, and never take a left- term.

8. If vehicles are fitted with a maruti ‘Yatra’, there is no apprehension or fear of an accident.

How to plan windows on a floor

Number of doors and windows on first floor should be lower (less) Than the ground- floor. similarly, doors ad windows o 2nd floor should be less than those on the 1st floor (In proportionate basis). This is an old technique which was based on volume of stone (s) and magnetic load. But, the said technique has been replaced/ changed in the age of still ad iron (concrete) where construction technique has gone a sea- change. Nowadays, there is, in vogue a technique where by each and every inch of lad is utilized. Hence, old technique does not fit in modern requirements.

Ideal Directions for Car Parking & Garage in Factory

1. North-East (NE) Zone – Light Vehicles / Visitor Parking
North-East is considered a light and positive zone.
Best suited for visitor vehicles, small cars, or two-wheelers.
Avoid storing heavy machinery or trucks in this area.

2. North or East Zone – Employee Parking

The North or East portion can be used for daily employee parking.
It ensures smooth entry and exit of vehicles and promotes a harmonious work environment.

3. South-West (SW) Zone – Garage / Heavy Vehicle Parking

South-West is ideal for heavy vehicles, trucks, or factory transport vehicles.
Provides stability, safety, and control over valuable assets.
Avoid clutter and maintain proper ventilation and accessibility.

4. South-East (SE) Zone – Special Use

Can be used for fuel storage, electric vehicles charging, or service area.
Avoid storing inflammable items near employee or visitor parking areas.

Design & Layout Tips

Maintain open pathways for smooth vehicle movement.
Keep parking areas clean, dry, and well-lit.
Slope the floor slightly towards the North or East to allow water drainage and prevent stagnation.
Avoid parking under a beam or directly in front of staircases, as it creates negative energy and obstructs flow.

Entrance & Exit Guidelines

The entrance to the parking area should ideally face North or East, allowing positive energy and smooth traffic flow.
Exit points should also be aligned in North or East directions.
Avoid South-facing entrances, as they can create energy obstacles and financial strain.

Benefits of Proper Vastu for Parking & Garage

Safe storage of vehicles and machinery
Reduced risk of accidents and damages
Smooth flow of materials and transport
Positive energy promoting employee efficiency
Financial stability and growth for the factory